30MPa Air Compressor Pump PCP 0-4500PSI Adjust High Pressure Auto Shut Air Pump.

Description

30MPa Air Compressor Pump PCP 0-4500PSI Adjust High Pressure Auto Shut Air Pump.
Description:
High Pressure 30Mpa electric pump can be used for fire fighting, air soft, paintball, leakage detecting, pressure-tight test, automobile tyres, etc.
The pressure value can be set arbitrarily, and it will stop automatically when it reaches the set pressure.
NOTE：We solemnly promise that every machine is brand new, and every machine has been tested when it leaves the factory. However, there may be a small part of oil residue due to the test.  If there is oil leakage due to transportation. Please contact us in time. We will provide a solution, thank you for your cooperation .
This is the installation video, if you don’t understand the use of this product, you can click on the link to take a look.
http://www.youtube.com/watch?v=IyMo5teOoLc
Operation instruction:
1. Take out the product; install the hose at the air outlet.(Note: gasket is needed, or air leakage might exist.)
2. Connect 2 cold water pipes and connect them to the water pump. (Note: the lower pipe connected to the water pump is water inlet; sinking pump is used in this product. The water pump should be immersed in water for using.)
3. Install the pressure relief valve screw; pressure relief valve screw is installed at the pressure relief hole under the hose.The blow-down valve is installed at the
drain outlet of the first air chamber block.
4. Immerse the water pump in water and switch on the power.
5. Connect the container need to be inflated, make sure the connection is correct.
6. Screw up the screws of the blow-down valve and pressure relief valve.
7. Switch on the power ant the machine operates. Note: when the machine is operating, the water must operate correspondingly, or the product might be damaged due to overheated, personal harm may even occur.
8. After the inflation is completed, screw of the pressure relief valve should be firstly loosen, then the power is to be switched off, by doing so, high pressure
air backlash caused due to sudden failure of power supply would be avoided, which could lengthen lifetime of the product, as well as discharge high pressure air in the machine.
9.Please make sure to use the ISO VG46 & AW46 standard oil.
Warning:
1. Please use the power supply according to the parameter table.
2. If abnormal noise occurred during the using of the product, please stop using it instantly and check the cause.
3. The product should be placed at a place that it couldn’ t be touched by children.
4. Please do not use it in moist and flammable place.
5. Please do not modify it arbitrarily, disassembling and repair by non-technical personnel is not allowed.
6. Make sure the socket could withstand a currentgreater than 8A before using it, or the circuit might be burnt, the product might be damaged and the dangers may be caused due to overload of the socket.
7. Please do not touch the head section after the machine was just being used, so as to not beburnt by high temperature.
8. Please do not leave without authorized, or the product might be damaged by increasingly rising pressure, sustained overload motor, even halt due to the operation pressure has reached but it is not turned off timely.
9. When it is used for inflating slightly larger container, the cooling water should be changed every 30 minutes, in this way, the cylinder
temperature could be better controlled.
10. The machine oil should be checked regularly, make sure the oil level is above the upper edge of the red point. If color of machine oil becomes dark and black, it should be changed in time.
Specifications:
1. Voltage: 110V
2. Power Rating: 1.8KW
3. Inflating Speed: 2800R/Min
4. Noise: MAX 85DB
5. Air Flow Rate: 40-50L/MIN; 1.5-1.8CFM
6. Working Pressure: 100-300BAR; 1500-4500PSI
7. Cooling System: Water Cooling
8. Compression Stage: Two Stage
9. Lubrication Mode: Splash Type
10. Material of Cover: Cast Aluminum
11. Shout Down:
The pressure value can be set arbitrarily, and it will stop automatically when it reaches the set pressure.
12. Pressure Indicate: Gauge
13. Filtration: Water/Oil Separator
14. Lubricating Oil: ISO VG46 or AW 46
15. Air Hose Connection: 8mm Quick Connect Fitting
Package Includes:
1   x   30Mpa Electric Compressor Pump
1   x    Water Pump
2   x   Water Pipe
1   x   Hose Female
1   x   Air cock
2   x   Pressure relief screw
1   x   Wearing parts
1   x   English Manual
1. We accept PayPal Only.
2.Immediate payment needs to be processed for items with Add to Cart option so that any promotional discounts can be applied to your order immediately.
1 .We do everything we can to ship your orders out as soon as possible.
2. We process orders within 1 business day after the payment was clear. Orders on Saturday or Sunday will be proceed on following Monday.
3.No local pick-up service will be provided.
Our 30-day Satisfaction Guarantee assures our customers that they will receive all orders promptly and exactly as described. In addition, it allows customers to return new and unused products in their original factory condition for any reason within 30 days from the date of purchase.
Notice:
1. All returns must be pre-approved by us and have a return merchandise authorization  number. Unauthorized returns will not be accepted.
2. Buyers are responsible for appropriate packing, returning shipping cost, insurance and returning the item in "new" condition. Used items will not be accepted for return.
3. We will replace the returning item with an identical item, issue a full store credit or a full refund.
If you have any questions or concerns about the product or the auction, please tell us. Will be responded to within 24 hours during business days.
On Jun-21-21 at 08:07:09 PDT, seller added the following information: